Toyota 02-8FDF15, Руководство оператора

Страница: 24 / 392

en
en-23
(1) Push
Horn button (Option)
The horn will sound when the button at the top
of the rear pillar assist grip is pressed. Use this
horn when backing up.
The horn will sound even when the ignition
switch is OFF.
(1) Lower
(2) Raise
Lift lever
Raises and lowers the forks.
Raise ..........................................Pull backward
Lower ......................................... Push forward
The lifting speed can be adjusted by how far
the accelerator pedal is depressed and how far
the lever is pull back.
The lowering speed can be adjusted only by
how far the lever is pushed forward.
Note:
The idling lifting speed increase function
(Option) automatically increases lifting speed
by engaging the lift lever.
Caution Caution
• After the OPS System operates, return
the accelerator pedal to its fully released
position and set the lift lever to the neu-
tral position, and sit on the seat to restart
the operation. (If you sit on the seat
while raising the lift lever, the forks will
start to move 1 second later.)
• If you sit on the seat while lowering the
lift lever, the forks will not lower due to
the return to neutral function.
• Always operate the lift lever while cor-
rectly seated.
• When the ignition switch is turned to
OFF and lowering the lift lever, the forks
will not lower. However, if the operator
sits in the normal seated position then
the ignition switch is turned to ON, the
forks will be lower even if the engine is
off. (Except mini-lever/joy stick models)
(1)
(1)
(2)
(1) Lift lever knob switch
Lift lever knob switch
(Option)
For vehicles with Multifunction display DX
(Option), pressing the lift lever knob switch
will display the weight of load.
Note:
• Operate this function when you are not per-
forming loading operations.
• When weighing the load, always remember
to position the load at a height of about
500mm above the ground and make the
mast perpendicular.
(1) Lift lock release bolt
Key-lift interlock
When the ignition switch is OFF, the lift will
not descend even if the lift lever is lowered.
However, if the operator sits properly in the
seat and turns the ignition switch ON, the forks
can be lowered even if the engine is off
(Except mini lever/joy stick models).
If the ignition switch cannot be turned ON for
whatever reason, loosen the manual lowering
valve located on the oil control valve beneath
the toe board, and operate the lift lever in the
downward direction.
Note:
Once the forks have been lowered with the lift
lock release bolt, close and lock the valve.
(1)
(1)
01_A5028-0EA04_En.fm 23 ページ ２０１２年１２月６日 木曜日 午後１２時４２分