Toshiba MMC-P0151H, Руководство по обслуживанию

Страница: 123 / 216

3-120
Before replacement Service P.C. board setting
J11 J12
J11 J12
Applicable models
¡ ¡
X
¡
1-way air discharge cassette type
Concealed duct type
X
¡
X
¡
All models
¡
X
¡
X All models
X X X X All models
Service P.C. Board Selection Information
[Concealed duct, 1-way air discharge cassette type]
Service P.C. board selection corresponded table (Main P.C. board MCC-1361)
The indoor control P.C. board (MCC-1361) can correspond to multiple models. When replacing P.C. board
assembly, set the DIP switch, rotary switch, and jumper(s) according to the following description.
Switch set up
1 SW01 Indoor unit No. : Match to No. which the rotary switch is set up.
: Master unit ...... 1
: Server units ..... 2 to 16
2 SW02 Network address : Match to set up contents of P.C. board before replacement.
3 SW03 : Match to set up contents of P.C. board before replacement.
4 SW05 (Bit 1) : Match to set up contents of P.C. board before replacement.
5 SW05 (Bit 2) : Set to OFF side.
6 SW06 : Match to set up contents of P.C. board before replacement.
7 SW07 : Match to set up contents of P.C. board before replacement.
8 SW08 Horse power set up : Match to set up contents of P.C. board before replacement.
Jumper set up
1 Match to the set up contents of P.C. board before replacement except for J11, J12 and J20.
2. J20 : If Auto-turn-louver is equipped, cut J20.
3. J11, J12 : See the P.C. board before relacement, according to the table below, cut jumper(s) if necessary.
O : Provided, X : None (cut)
Service P.C. board part name : <MCC-1361>
CM02C06S
SN 4316V165