Toshiba GRZ100 B Series, Инструкция по эксплуатации

Страница: 210 / 447

⎯
209
⎯
6 F 2 S 0 8 4 6
•
Press the
END
key to return to the "Setting" screen.
Assigning signals
•
Press 2 on the "Setting" screen to display the "Input to logic gate" screen.
/ 5 I n p u t t o l o g i c g a t e 1 / 6
I n # 1 ( 0 - 0 7 1 ) ： 2 1
I n # 2 ( 0 - 0 7 1 ) ： 4
I n # 3 ( 0 - 0 7 1 ) ： 6 7
I n # 4 ( 0 - 0 7 1 ) ： 0
I n # 5 ( 0 - 0 7 1 ) ： 0
I n # 6 ( 0 - 0 7 1 ) ： 0
3
3
3
3
3
3
•
Assign signals to gates (In #1- #6) by entering the number corresponding to each signal
referring to Appendix B.
Note:
If signals are not assigned to all the gates #1-#6, enter 0 to the unassigned gate(s).
Repeat this process for the outputs to be configured.
4.2.6.10 LED
Four LEDs of the GRZ100 are user-configurable. Each is driven via a logic gate which can be
programmed for OR gate or AND gate operation. Further, each LED has a programmable reset
characteristic, settable for instantaneous drop-off, or for latching operation. The signals listed in
Appendix B can be assigned to each LED as follows.
Selection of LED
•
Press 9 (= LED) on the "Setting (change)" screen to display the "LED" screen.
/ 2 L E D
S e l e c t L E ( 1 - D 4 )
S e l e c t N o . =
•
Enter the LED number and press the ENTER key to display the "Setting" screen.
/ 3 S e t t i n g ( L E D 1 )
1 = L o g i c g a t e t y p e & r e s e t
2 = I n p u t t o l o g i c g a t e
Setting the logic gate type and reset
•
Press 1 to display the "Logic gate type and reset" screen.
/ 4 L o g i c g a t e t y p e & r e s e t 1 / 2
L o g i c 1 = O R 2 = A N D 1
R e s e 0 = I n s t t 1 = L a 1 t c h
•
Enter 1 or 2 to use an OR gate or AND gate and press the ENTER key.
•
Enter 0 or 1 to select “Instantaneous reset” or “Latch reset” and press the ENTER key.
•
Press the END key to return to the "Setting" screen.