Toshiba GRZ100 B Series, Инструкция по эксплуатации

Страница: 209 / 447

⎯
208
⎯
6 F 2 S 0 8 4 6
•
Enter 1 (= Normal) or 2 (= Inverted) and press the ENTER key for each binary input.
4.2.6.9 Binary Output
All the binary outputs of the GRZ100 except the tripping command, signal for command
protection and relay failure signal are user-configurable. It is possible to assign one signal or up to
6 ANDing or ORing signals to one output relay. Available signals are listed in Appendix B.
It is also possible to attach a delayed drop-off delay time of 0.2 seconds to these signals. The delay
drop-off time is disabled by the scheme switch [BOTD].
Appendix D shows the factory default settings.
To configure the binary output signals, do the following:
Selection of output module
•
Press 8 (= Binary output) on the "Setting (change)" screen to display the "Binary output"
screen. The available output module(s) will be shown. (The screen differs depending on the
relay model.)
/ 2 B i n a r y o u t p u t
1 = I O # 2 = I O # 2 3
•
Press the number corresponding to the selected output module to display the "Binary output"
screen.
/ 3 B i n a r y o u t p u t ( * * * * * )
S e l e c t B O ( 1 - * * )
S e l e c t N o . =
Note:
This setting is required for all of the binary outputs. If any of the binary output is not used, enter
0 to the logic gates #1-#6 in assigning signals.
Selecting the output relay
•
Enter the output relay number and press the ENTER key to display the "Setting" screen.
/ 4 S e t t i n g ( B O 1 o f I O # 2
1 = L o g i c g a t e t y p e & d e l a y t i m e r
2 = I n p u t t o l o g i c g a t e
)
Setting the logic gate type and timer
•
Press 1 to display the "Logic gate type and delay timer" screen.
/ 5 L o g i c g a t e t y p e & d e l a y t i m e r 1 / 2
L o g i c 1 = O R 2 = A N D 1
B O T D 0 = O f f 1 = O n 1
•
Enter 1 or 2 to use an OR gate or AND gate and press the ENTER key.
•
Enter 0 or 1 to add 0.2s delayed drop-off time to the output relay if required and press the
ENTER key.