GTCOM2 User manual
4 |
E N
1
General information
1.1
Short description of the operation principle
Figure 1 Structural schematic with usage
-
The GTCOM2 (further referred to as the module)
transfers messages about events of the security system to the mobile ph
one of a user
via GSM communication channel.
-
The module
receives Contact ID DTMF codes
from the dial-up communicator of security control panel,
converts them into readable texts
and sends SMS message to the mobile phone
of a user.
-
It is possible to check the status, control the panel via
mobile app
.
-
GTCOM2 and primary panel status synchronization
:
o
To control primary alarm panel from GTCOM2 and see the status in app
o
To control GTCOM2 from primary alarm panel and see the status in keyboard.
-
Upon alarm occur, the module will generate SMS message
about alarmed sensors. Door, PIR, Fire etc. SMS message is being sent to a
user in-line with a short call. This is to reduce the probability that a user will not observe SMS message.
-
It is possible to send
SMS and to call to 8 users
. The algorithm of message sending is SMS1, SMS2...SMSn till all SMS messages will be
send. After DIAL1,DIAL2....DIALn.
-
It is possible to send
alarm events to the monitoring station, to the standard SIA DC-09 receiver
via global internet
1.2
Specifications
Connects to panel
Landline dialer (TIP RING contacts)
Inputs, Outputs
- 2 programmable selectable inputs or outputs (I/O1, I/O2);
- 2 digital inputs for Wiegand reader;
- 1 input for 1-wire sensors, iButtons;
- RS485 Bus
- Outputs could be controlled via mobile, web app, iButton keys, RFID cards, short call, sms.
- Selectable type of inputs: NC; NO; NC/EOL; NO/EOL; NC/DEOL; NO/DEOL
Modem
2G modem frequencies 850 / 900 / 1800 / 1900 MHz
3G modem frequencies 800 / 850 / 900 / 1900 / 2100 MHz
4G modem frequencies Depends on region
Power supply voltage
DC 10-16V Max 0,2A
