GTCOM2 User manual
15 |
E N
Refer to:
Access control. Arming/Disarming methods
Users & Access Control programming details.
DISARM /ARM/SLEEP/STAY the security system
Reporting SMS&Dial in Case of Alarm Events
3.3.3
Arming/Disarming methods
Arming process:
If ready
(no violated zone/tamper),
the system will arm
.
If unready
(violated zone/tamper is present), the system will not arm and
provide a list of violated zones/tampers
by SMS text message
to user phone number. In such case the user
must restore all violated zones and tampers
before arming the system. Alternatively, the
violated zones can be
bypassed, disabled or a Force
attribute enabled, and the tampers can be disabled when arming. The system initiates
the exit delay countdown intended for the user to leave the secured area.
The alarm will be caused even if a tamper is violated while the system is disarmed
Due to security reasons it is highly recommended to restore the violated zone/tamper before arming the system.
Access control methods is defined in Sera2> User/ Access control window
Figure 15Users/ Access control window
Arm/Disarm by mobile, web app
Tap the ARM, ARM (Stay), ARM (Sleep), DISARM in the mobile, web app> System window
Arm/Disarm by call
It is possible to arm, disarm the system and turn OFF the alarm by dialing the system‘s phone number from any of 800 available user
phone numbers The system
ignores any incoming calls from a non-listed phone number
.
The phone call is free of
charge
as the system rejects it and carries out arming/disarming procedure afterwards. If there is more than one listed user dialing to the
system at the same time, the system will accept the incoming call from the user who was the first to dial while other user (-s) will be ignored.
To disable/enable arming or disarming for certain listed user phone numbers
, please mark near ARM/DISARM in the “Users & Remote
control” window
Figure 16 ARM/ DISARM by call settings
Arm/Disarm via SMS
Enter user phone number in the Sera2> Users/ Access control list
The system
rejects the SMS text messages containing wrong SMS password
even from a listed user phone number. To
arm the system by SMS text message, send the following text to the system‘s phone number USER 123456˽030˽ST
030= command code (Change security system’s mode (ARM/DISARM/STAY/SLEEP)
