GTCOM2 User manual
11 |
E N
GTCOM2 can simulate PSTN line, receive DTMF Contact ID messages and convert them into readable format as well as to send SMS
message to a user via GSM network.
3.2
Programming the control panel
Configuration of the panel PSTN communicator should be the similar as event transmission to the monitoring station receiver in CONTACT ID DTMF
protocol. Practically the module can work with any central panel which has PSTN communicator and meets Ademco Contact ID data format according to
SIA SIA DC-05 standard. Also Central panel must support phone number dialing using DTMF tones.
Pulse dialing is not supported by GTCOM2
Panel’s PSTN communication settings:
o
Set communication enabled
o
Se
t communicator account number 4 digits. E.g. “1234”
o
Set communications Telephone. Enter the monitoring station receiver’s telephone number (you can use any number longer than 2
digits. The GTCOM2 pick up and answer when the panel calls to any phone numbe
r). Telephone number e.g. “1234” .
o
Set communication dialing options to [DTMF Dialing]
*
o
Set Communications protocol to [DTMF Contact ID]*
o
If panel has such option set [Contact ID Automatic Reporting Codes]
o
Enable PSTN communication events upon your needs Open/Close/Alarm/Restore/Maintenance/Test
Panel’s settings for two ways ARM/DISARM synchronization
***. [APP/Call/SMS/iButton]-GTCOM-PANEL-[Panel Keyboard]
o
Set Panel’s Keyswitch Zone (maintained/Level Mode) it will get ARM/DISARM signal from GTCOM2 [System Armed state] Output
PGM
o
Set panel’s PGM to [System Armed Status] level mode. It will send ARM/DIARM signal to GTCOM2 keyswitch input
*Communicator's data package protocol SIA Ademco CONTACT ID is being supported (according to SIA DC-05 standard)
*Telephone number and data transfer format DTMF (tone)
*** Two ways ARM/DISARM synchronization means USER able to control panel via panel’s keyboard as well as remotely form GTCOM2
APP/WEB/SMS/iButton/RFID/Call. This means that the GTCOM2 APP will show the same system status as keyboard of security panel.
3.3
Programming GTCOM2 communicator
GTCOM2 and primary panel synchronization
https://youtu.be/kOZI03d4hqg
