TESTO 350 Maritime V2, Инструкция по эксплуатации

Страница: 68 / 106

6 Using the product
68
Parameter Function
Stop Determining the stop criterion
•
The measuring program is stopped at any
time (the function key automatically changes
to the start function)
• Time
The recoding of readings stops at a desired
time.
• External signal
Trigger signal to control the stop of
measuring programs.
• Duration
Setting cycles to save readings.
• Memory full
Saving readings ends when the memory is
full.
Gas time Selection of gas time cycle
Rinse time
Enter the rinse time (see Recommendation for
emission measurements over an extended
period of time, page 102).
The measurement program always
begins with a rinse phase (duration: 30
sec).
Measuring phases (gas time) and rinsing
phases (rinsing time) alternate according
to the programmed values.
Meas. rate The meas. rate is the saving cycle for mean
values It is programmed in units of seconds,
minutes, whereby the smallest possible meas.
rate depends on the number and type of
connected probes.
1. Select the program: [ ] , [ ] → [OK] .
2. Press
[Change]
.
3. Press [Change] .
4. Edit program name: [ ] , [ ] , [ ◄ ] , [ ► ] .
5. Confirm the entry: [OK] .
6. Repeat steps 4 and 5 as required.
7. Press [Next] .