Tektronix DM 5010, Инструкция по эксплуатации

Страница: 114 / 347

DM 5010 Instrument Interfacing Guide
Sample Measurement Program
The following program makes a series of DM 5010 measurements to illustrate command i/o and various measure­
ment triggering modes.
Figs. 3 and 4 are typical output from the programs.
405XR14:
100 REM
110 REM
120 REM
130 REM
140 REM
150 REM
160 REM
170 REM
180 REM
190 REM
200 REM
210 REM
220
REM
230 REM
240 REM
250 REM
260 REM
270 REM
280 REM
290 REM
300 REM
310 REM
320 REM
330
REM
340 REM
350 REM
360 REM
370 REM
380 REM
390 REM
400 REM
410 REM
420 REM
430 REM
440
REM
450 REM
460 REM
DM 5010/4050-SERIES MEASUREMENT PROGRAM
BY Jim Kimball, GPI Market ins.
Copyright (c) 1982, Tektronix,
software is provided on an "as
kind. It is not supported.
10/15/82, update 11/17/82
Inc.
All rights reserved. This
is" basis without warrants of any
This software may be reproduced without prior permission, in
whole or in part. Copies must include the above copyright
and warranty notice.
REQUIRED EQUIPMENT
DM 5010 in TM 5000 mainframe.
Program assumes no other i nst ruments- on the bus.
4050-Series controller with R14 GPIB Enhancement rompack
PURPOSES
Inputs four readings, using four different DM 5010 acquisition
modes. Prints readings on screen.
OPERATING PROCEDURE:
Connect 4050 Controller and TM 5000 mainframe with GPIB cable.
DM 5010 must be set for primary address of 16 or
change line that assigns d-16.
Enter'and run program (no other program segment required).
PROGRAM FUNCTIONS:
Prepares DM 5010 for measurement and queries id
Reads whatever measurement is available
Triggers
a reading with the INPUT statement
Reads after GET
trigger in device trigger mode
Gets average of 20 DM 5010 readings using SEND
General-purpose SRQ handler
470
REM
480 REM
490 INIT
500 PAGE
510 PRINT "GDM 5010 MAKING MEASUREMENTS."
520 REM Assign DM 5010 factory-set address of 16
530 D=16
540 ON SRQ THEN 950
550 CALL "SRQON"
560 REM
570
REM Setup DM 5010: expand as needed
580 PRINT 8D:"init"
10