TECO 7300EV, Быстрый старт, Страница: 66 / 93

Chapter 4 Software index
4-33
C46 (Option card) Multi-function output T+ ， T-
000: In running
001: Frequency reached [Preset target frequency ± F23]
002: Frequency reached [ Preset output frequency level (F22) ±F23]
003: Frequency detection (>F22)
004: Frequency detection (<F22)
005: Fault .
006: Auto-restart
007: Momentary power loss
008: Emergency Stop (E.S.)
009: Base Block (b.b.)
010: Motor overload protection
011: Inverter overload protection
012: retain
013: Power ON
014: Communication error
015: Output current detection
Refer to F21 description:
C47 Remote keypad control
selection
000: Disable
001: Enable. Operation according to F09 as wire breaks.
002: Enable. Operation at the last set frequency as wire
breaks
.
(Stop mode by Inverter keypad or F04 parameter as
appropriate).
When C47=001
，
C49~C53 set parameter disable, following parameter will be auto set:
Inverter communication address No 1 Data bytes: 8 bit
Baud rated (bps): 38400 Parity bytes: no parity
Stop bytes: 1 bit
Not ※ e:1. Connect remote keypad in stop mode, control priority is with Remote keypad •
2. If the remote keypad is connected in run mode, it will not be effective until the
inverter is in stop mode.
C48 Copy module
000: Copy module Disabled
001: Copy to module from inverter ( Read)
002: Copy to inverter from module ( write)
003: Read/ write check (Compare the parameters).
Note: Module copy function is applicable only to inverters
with the same voltage and KW rating.
C49 set communication address, for the specific inverter when multi-inverters are controlled by
communication method.
C50 Baud rate (bps)
000: 4800
001: 9600
002: 19200
003: 38400
C49 Inverter communication address: 001~ 254