TECO 7300EV, Быстрый старт, Страница: 44 / 93

Chapter 4 Software index
4-11
2.) F5=002,when one of parameter group F11~ F15 is set to 015 and multi-function input terminal
is OFF, the frequency is set by analog signal (auxiliary speed) from TM2. If the multi-function
input terminal ON, the frequency is set by VR on Keypad.
3.) Up/Down terminal: please refer to description of parameter group F11~ F15(multi-function
input terminal).
4.) Priority of reading frequency command: Jog> preset frequency > (Keypad
Ÿź
or TM2 UP/
Down or communication)
F06 : External control operation mode 000: Forward/ Stop-Reverse/Stop
001: Run/ Stop-Forward/Reverse
002: 3-wire—Run/ Stop
1.) F06 is only available when When F04 = 001 (external terminal).
2.) When both forward and reverse commands are ON, it will be take into Stop.
※
• ••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
••••
~
•••••••••••••••••••••
(1). NPN input signal:
S1 ( Forward/Stop )
S2 (
Reverse/Stop
)
COM ( Common)
(2). PNP input signal:
Parameter F06 = 001, Control method is as following:
(1). NPN input signal:
S1 (
Run/Stop
)
S2 ( Forward / Reverse )
COM ( Common)
(2). PNP input signal:
S1 ( Run/Stop )
S2 ( Forward / Reverse )
24V ( Common)
Parameter F06 = 002, Control method is as following:
(1). NPN input signal: (2). PNP input signal:
S1 ( Run )
S2 ( Stop )
S3 (
Forward/ reverse
)
COM ( Common)
S1 ( Run )
S2 ( Stop )
S3 ( Forward/ Reverse )
24V
(Common
)
S1 (
Forward/Stop
)
S2 ( Reverse/Stop )
24V ( Common)
Parameter F06 = 000, Control method is as following: