
Chapter 4 Software index
4-32
C41 Load /Remote control select explain
• Locad mode
Run command
Only Run/Stop pad on the keypad can control and F04 setting have no relationship.
Frequency command
When C41=000: only UP/DOWN pad on the keypad can control and F05 setting have no
relationship.
When C41=001: only VR on the keypad can control and F05 setting have no relationship.
• Remote mode
Run command from the run parameter (F04) set
Frequency command from the frequency parameter (F05) set
• Control select mode pad is V/RESET and DATA/ENT pads push down on the same time can
change control mode.(Must be inverter stop state)
Refer t o F11~F14
1.) If the C44 scan time is set to say 80 ms (i.e N=10) then digital input signals on for less then 80
msec will be ignored.
2.) If scan the same input signal for N times (scan times), the inverter takes it as normal one. If it is
less than N times, it will be taken as noise. One scan time: 8ms.
3.) User can set scan interval time according to noise in the operation environment. Extend C44/C45 as
noise is serious, however this will reduce the scan response time.
C42/43 (option card)
S5/S6 terminal on MFIT Setting
000: Forward
001: Reverse
002: Preset Speed Command 1
003: Preset Speed Command 2
004: Preset Speed Command 3
005: Jog Frequency Command
006: Emergency Stop (E.S.)
007: Base Block (b.b.)
008: Switching to 2
nd
acceleration/ deceleration time.
009: Reset
010: Up Command
011: Down Command
012: Control signal switch
013: Communication control signal switch
014: Acceleration/ deceleration disable
015: Master/ auxiliary speed switch
016: PID function disable
C44: Multi-function input terminal S1~S6 signal scan time (N. msec ×8), N = (1~100 times).
C45: AIN signal scan time (N. msec ×8), N = (1~100 times).
Содержание 7300EV
Страница 14: ...Chapter 3 Environment description and installation 3 4 z EV 1P2 1P5 101 2P2 2P5 201 N4S install TM1 TM2 ...
Страница 15: ...Chapter 3 Environment description and installation 3 5 z EV 1P2 1P5 101 2P2 2P5 201 N4 install TM1 TM2 ...
Страница 86: ...Chapter 6 Peripherals 6 4 z JNFS21015 22 07 FOR EV 202 203 H1 z JNFS21016 15 07 FOR EV 202 203 H3 ...
Страница 87: ...Chapter 6 Peripherals 6 5 z JNFS20858 7 07 FOR EV 401 403 H3 ...