tbs electronics ATP1-120, Инструкция по эксплуатации

Страница: 61 / 81

54
Cause – Excessive level of reagent in the bottle.
Solution – Verify reagent levels.
7 - F I L E N O T F O U N D
A file has not been found or an incomplete file has been found in the computer
memory; the recovery systems will replace the lost or incomplete file from a backup
copy.
Cause – The buffer battery of the CPU memory is exhausted.
Solution – No intervention by the user is possible. If the problem persists,
contact TBS
®
technical service.
8 - L O N G D R A I N
The time required to drain the retort was excessive.
Cause – Insufficient pressure in the retort due to: inefficient air pump, an air
leak in the pneumatic circuit or an air leak from the retort lid gasket.
Solution – Check the retort lid gasket; contact the TBS
®
service department
for other causes.
9 - T ° W A X L O W
During the process but before the first paraffin (step 11), the temperature of the
paraffin chamber has dropped too low; the process will continue until the last
reagent. If during the draining of the last reagent the problem persists, the process
will be stopped. (See also Alarm 20.)
Cause – The thermo-regulation system of the paraffin chamber is out of
order.
Solution – No intervention by the user is possible. If the problem persists,
contact the TBS
®
service department for technical assistance
1 1 . 3 – B
L O C K I N G
A
L A R M S
1 1 - F I L L N O V A C U U M
The instrument was unable to produce a vacuum in the Retort while attempting to fill
from a reagent or paraffin station.
Cause – During the filling stage, a serious leak in the pneumatic or hydraulic
circuit occurred; a failed pump; an almost empty reagent bottle; or incomplete
closure of the retort lid.
Solution – Check the bottle reagent level and quick connector o-rings as well
as the Retort lid gasket. If the problem persists, contact the TBS
®
service
department for technical assistance.