TANDBERG E5500, Инструкция по эксплуатации

Страница: 49 / 256

Installing the Equipment
Page 2-20 Instruction Manual: evolution 5000 E5500 Mobile Contribution Encoder
ST.TM.E10033.3
Internal Remux Option (M2/EOM1/REMUX)
DVB ASI IN 1, 2 and 3
75
Ω BNC connectors provide inputs to
the unit.
Table 2.19: DVB ASI IN Connector
Pin Signal
Centre Signal
Screen Ground
DVB ASI OUT 1
A 75
Ω
BNC connector provides an output
from the unit.
Table 2.20: DVB ASI OUT Connector
Pin Signal
Centre Signal
Screen Ground
2.6 Powering Up/Down
2.6.1 Before Powering Up
Before powering-up the MCE, check that:
1.
The unit has been installed in a suitable location.
2. The unit has been connected to external equipment and power supply,
as required.
3. The power supply has been checked and a good earth provided.
4. The correct fuse type and rating has been fitted to both the equipment
and the ac power cable.
2.6.2 Powering Up
To power up the MCE:
1.
Turn on the local mains supply to apply power to the equipment.
2. The MCE executes a series of power-up initialisation and self-test
routines.
3. Ensure that all cooling fans are rotating. If they are not, switch off the
equipment immediately.