TANDBERG E5500, Инструкция по эксплуатации, Страница: 78 / 256

Operating the Equipment Locally
Instruction Manual: evolution 5000 E5500 Mobile Contribution Encoder Page 3-27
ST.TM.E10033.3
The following screen is displayed. Press the Yes softkey to switch
modulation back on and return to the menu, or press the No softkey to
return to the menu and leave modulation switched off.
S e t up / Op e ra t io n s E di t
T x Ba n dw i dt h Yes
2 5 . 70 0 0 M Hz No
*
S w i tc h M o du l at i on Ba c k O N? Quit
If the specified bandwidth is outside the valid input range, a confirmation
screen similar to the following is displayed which shows the maximum/
minimum value allowed. Press the Enter softkey to accept the new value
shown, or press the Quit softkey to leave the original bandwidth
unchanged (modulation remains switched off).
C o n fi r ma t io n S c re e n
T x Ba n dw i dt h
S p e ci f ie d V a lu e T o o H ig h
S e l ec t < E nt e r> to Se t t o
Enter
M a x im u m : 3 8. 4 00 0 M H z Quit
Modulation and/or IF Output Switched Off
If modulation and/or the IF output are switched off, the option is used in
the same way as described above, except that the screens to switch
modulation off and then back on are not displayed.
3.6.7 Symbol Rate Option
Modulation and IF Output Switched On
The screen shown below is displayed. In order to change the symbol rate,
modulation must first be switched off. Press the Yes softkey to do this
automatically (and proceed to the next screen), or press the No (or Quit)
softkey to return to the menu.
S e t up / Op e ra t io n s E di t
S y m bo l R a te Yes
2 0 . 00 0 0 M sy m /s No
*
S w i tc h M o du l at i on OF F ? Quit
When modulation is switched off, the screen shown below is displayed. Use
the + and – softkeys to increment or decrement the symbol rate, or enter
a new value using the keypad. Press the Enter softkey to accept the new
value.