TANDBERG E5500, Инструкция по эксплуатации

Страница: 94 / 256

Operating the Equipment Locally
Instruction Manual: evolution 5000 E5500 Mobile Contribution Encoder Page 3-43
ST.TM.E10033.3
UTC Hour Offset Option
The Universal Time Co-ordinate (UTC) is effectively the same as Greenwich
Mean Time (GMT). When including SI in the output transport stream the
MCE is required to output a Time and Date Table (TDT). This uses UTC.
Therefore, as the local time is input on the front panel a UTC offset is
needed so that the UTC time for the TDT table is generated.
To access the UTC Hour Offset option, press the UTC Hour Offset softkey
in the
General Menu
. Edit the offset by use of the softkeys or the keypad
and then press the Enter softkey.
Setup/System/General Edit
UTC Hour Offset (+ E, - W) +
0 —
Enter
Update using keypad or softkeys Quit
Table 3.17: UTC Hour Offset Options
Selected Option Description
Min: –12 Hours
Max: 12 Hours
Step Size: 1 Hour
UTC hour offset. A positive value indicates East of
Greenwich, and a negative value indicates West of
Greenwich.
If the specified UTC offset is outside the valid input range, a confirmation
screen is displayed which shows the maximum/minimum value allowed.
Press the Enter softkey to accept the new value shown, or press the Quit
softkey to leave the original UTC offset unchanged.
Confirmation Screen
UTC Hour Offset (+ E, - W)
Specified Value Too High
S e l ec t < E nt e r> to Se t t o
Enter
M a x im u m : 1 2 H ou r Quit
IP Address Option
To access the IP Address option, press the IP Address softkey in the
General Menu
. Edit the IP address by use of the keypad and then press
the Enter softkey.
Setup/System/General Edit
IP Address Del
172.16.248.91 Case
Update using keypad Enter
(Upper case) Quit
Press the + and -
softkeys to increment
and decrement the
offset.