Sun Microsystems Solaris 7 11/99, Руководство по аппаратной платформе

Страница: 104 / 224

92 Solaris 7 11/99 Sun Hardware Platform Guide • November 1999
4. If any of the NVRAM configuration variables have been customized, the update
displays both the default value and the customized (current) value.
5. Take note of the variables and values for current settings.
Either write down the current values or mark up the
eeprom
output you captured in
“To Capture the Configuration Variable Settings” on page 86 so that you know
which NVRAM configuration variables will need to be changed from their default
values after the flash PROM update.
If the keyswitch is set to the locked position, you will see the following error
message..
6. Make the flash PROM write-enabled by turning the keyswitch to the On or
Diagnostics position then type
reboot
at the # prompt
Verifying Checksums: Okay
Do you wish to flash update your firmware? y/[n] : y
**IMPORTANT** As a consequence of the firmware upgrade that is
about to take place, it is very possible that the customized values
in the configuration variables will revert to their *default
values* upon the next system power-cycle or soft-reset. If this
happens, it could have a significant effect on the behavior of the
system after the power-cycle or soft-reset.
Following is a list of the system's NVRAM configuration variables
which have been customized (i.e. they are different than the
default values).
You may wish to write down the values of the indicated
configuration variables so that they may be restored (if necessary)
after the next power-cycle or soft-reset.
Name: auto-boot?
Default: true
Current: false
Name: boot-file
Default: <null>
Current: kadb -d
FPROM Write Protected: Check Write Enable Jumper or Front Panel
Key Switch.