Sun Microsystems Solaris 7 11/99, Руководство по аппаратной платформе

Страница: 121 / 224

Chapter 6 Installing the Solaris Operating Environment With the SPARCstorage Array 109
5. If you need to upgrade your FCode, use the
ssaadm
command:
6. Halt the system:
7. If you downloaded new firmware, press the
SYS OK
button on the back of the
SPARCstorage Array(s) to reset.
Note – Before booting your system, wait for the SPARCstorage Array to complete
POST.
8. Reset and boot your system:.
Note –
You have completed the new installation of Solaris 7 11/99 operating
environment. If you would like to install disk management software, refer to your
disk management software documentation.
Troubleshooting
If your system does not boot, check that:
■
Your boot-device environmental variable is correctly set to your boot device.
■
The FCode revision level is at 1.33 or higher if you are attempting to boot through
an FC/S SBus Card. To check the FCode revision level, refer to “To Check the
FCode Level of Your FC/S SBus Card” on page 110.
# ssaadm fc_download
# /usr/sbin/init 0
ok reset
ok boot