Subaru B9 TRIBECA WX 2007, Руководство пользователя

Страница: 65 / 861

AB-14
Driver’s Airbag Module
AIRBAG SYSTEM
4. Driver’s Airbag Module
A: REMOVAL
CAUTION:
Refer to “CAUTION” of “General Description”
before handling the airbag module. <Ref. to AB-
4, CAUTION, General Description.>
1) Position the front wheels straight ahead. (After
moving a vehicle more than 5 m (16 ft) with front
wheels positioned straight ahead, make sure that
the vehicle moves straight ahead).
2) Turn the ignition switch to OFF.
3) Disconnect the ground cable from battery and
wait for at least 20 seconds before starting work.
4) Using TORX
®
BIT T30 (1), remove the two
TORX
®
bolts on the side of steering wheel.
5) Disconnect the horn harness.
6) Disconnect the airbag connector on the back of
airbag module, and then remove the airbag mod-
ule. <Ref. to AB-8, PROCEDURE, Airbag Connec-
tor.>
7) Refer to “CAUTION” for handling of a removed
airbag module. <Ref. to AB-4, CAUTION, General
Description.>
B: INSTALLATION
CAUTION:
• Refer to “CAUTION” of “General Description”
before handling the airbag module. <Ref. to AB-
4, CAUTION, General Description.>
• To prevent the misconnection, the connector
is colored. Connect the harness side connector
to the same color of module side connector.
Install in the reverse order of removal.
Tightening torque:
10 N·m (1.0 kgf-m, 7.2 ft-lb)
C: INSPECTION
CAUTION:
Refer to “CAUTION” of “General Description”
before handling the airbag module. <Ref. to AB-
4, CAUTION, General Description.>
Check for the following, and replace the damaged
parts with new parts.
• Airbag module, harness, connector and mount-
ing bracket are damaged. <Ref. to AB-11, DRIV-
ER’S AIRBAG MODULE, INSPECTION,
Inspection Locations After a Collision.>
CC-00018
(1)
AB-00622
asieps_tobira.book 14 ページ ２０１２年２月１０日 金曜日 午後３時２６分