Subaru B9 TRIBECA WX 2007, Руководство пользователя

Страница: 513 / 861

AC-34
Compressor
HVAC SYSTEM (HEATER, VENTILATOR AND A/C)
14.Compressor
A: INSPECTION
1. MAGNETIC CLUTCH CLEARANCE
Check the clearance of the entire circumference
around the drive plate and pulley.
Standard:
0.45
±
0.15 mm (0.0177
±
0.0059 in)
2. MAGNETIC CLUTCH OPERATION
1) Disconnect the compressor connector.
2) Connect the battery positive (+) terminal to the
compressor connector terminal, and the negative
(–) terminal to the compressor body.
3) Check the magnet clutch engagement.
If there is a problem, replace the compressor.
B: REMOVAL
1) Perform the compressor oil return operation.
<Ref. to AC-26, PROCEDURE, Compressor Oil.>
2) Turn the A/C switch to OFF and stop the engine.
3) Using the refrigerant recovery system, dis-
charge refrigerant. <Ref. to AC-21, PROCEDURE,
Refrigerant Recovery Procedure.>
4) Disconnect the ground cable from the battery.
5) Remove the V-belts. <Ref. to ME(H6DO)-40,
REMOVAL, V-belt.>
6) Remove the generator. <Ref. to SC(H6DO)-19,
REMOVAL, Generator.>
7) Remove the bolt and remove the low-pressure
hose and high-pressure hose.
8) Disconnect the compressor harness from the
body harness.
9) Remove the bolts and remove the compressor
bracket.
10) Remove the bolts, then remove the bracket
from the compressor.
C: INSTALLATION
1) Install in the reverse order of removal.
2) Replace the O-rings on low/high pressure hoses
with new parts, then apply compressor oil.
3) After replacing the compressor, adjust the
amount of compressor oil. <Ref. to AC-26, PRO-
CEDURE, Compressor Oil.>
4) Charge refrigerant. <Ref. to AC-22, PROCE-
DURE, Refrigerant Charging Procedure.>
Tightening torque:
Refer to “COMPONENT” of “General Descrip-
tion”. <Ref. to AC-11, AIR CONDITIONING
UNIT, COMPONENT, General Description.>
<Ref. to AC-12, COMPRESSOR, COMPO-
NENT, General Description.>
AC-01287
AC-01381
AC-01289
AC-01290
asieps_tobira.book 34 ページ ２０１２年２月１０日 金曜日 午後３時２６分