Subaru B9 TRIBECA WX 2007, Руководство пользователя

Страница: 739 / 861

SB-11
Front Seat Belt
SEAT BELT SYSTEM
B: INSTALLATION
1. OUTER SEAT BELT ASSEMBLY
Install in the reverse order of removal.
CAUTION:
• The parts of driver and passenger sides are
not the same. Before installation, make sure
that the correct part is used.
• Be careful not to twist the seat belts during
installation.
Tightening torque:
<Ref. to SB-2, FRONT SEAT BELT, COMPO-
NENT, General Description.>
2. INNER SEAT BELT ASSEMBLY
Install in the reverse order of removal.
CAUTION:
• After the driver’s and passenger’s inner seat
belt assembly installation, check that the seat
belt buckle switch operates normally using the
Subaru Select Monitor in {Status Data} of “Air-
bag System”. <Ref. to AB(diag)-33, DISPLAY
OF STATUS INFORMATION, OPERATION, Sub-
aru Select Monitor.>Improper buckle switch op-
eration may cause airbag system malfunction.
• Inner seat belt assembly harness (1) must be
routed securely as shown in the figure, as it can
affect the performance of the seat position sen-
sor and occupant detection system.
• Driver’s seat
• Passenger’s seat
Tightening torque:
<Ref. to SB-2, FRONT SEAT BELT, COMPO-
NENT, General Description.>
C: INSPECTION
1. OUTER SEAT BELT ASSEMBLY
Check for the following, and replace with new parts
if necessary.
• Pretensioner is cracked or deformed.
• The belt tension sensor is cracked. Or deformed.
• Seat belt is slackened, bent or worn. Seat belt is
abnormally wound or extended.
2. INNER SEAT BELT ASSEMBLY
Check for the following, and replace with new parts
if necessary.
• Inner seat belt assembly is deformed or dam-
aged.
• Seat belt buckle cannot be engaged properly.
SB-00317
(1)
SB-00318
(1)
asieps_tobira.book 11 ページ ２０１２年２月１０日 金曜日 午後３時２６分