Subaru B9 TRIBECA WX 2007, Руководство пользователя

Страница: 426 / 861

GW-19
Windshield Glass
GLASS/WINDOWS/MIRRORS
B: INSTALLATION
1) Clean the external circumference of windshield
glass with alcohol or white gasoline.
2) Remove the adhesive layer on the body using
cutter knife to obtain smooth face of 2 mm (0.08 in)
thick.
CAUTION:
Be careful not to damage the body and paint
surface.
3) Clean the body with alcohol or white gasoline to
eliminate cutting powder, dust and dirt completely
from body.
4) Install the dam rubber.
5) Attach the molding to glass.
(1) Align the molding (A) to both the upper edge
ends of windowshield glass (C).
(2) Install the molding from upper corners to-
wards center.
(3) Install the molding from upper corners
downward.
(4) Apply the double-sided tape (B) uniformly
on the side section of glass.
6) Apply the seal (2) to terminal section of front re-
inforce side panel (1) and the intersection point (3)
of front reinforce side panel and front pillar out pan-
el.
7) Apply two types of primers to the adhesive layer
of glass using sponge.
Glass primer:
Dow Automotive
ESSEX U-401, U-402
8) Apply the primer to the adhesive layer of body.
Painted surface primer:
Dow Automotive
ESSEX U-413
NOTE:
• Primer once attached to the painted surface of
the body and internal trim is hard to wipe off. Mask
the circumference of such area.
• Let primer dry for about ten minutes before in-
stalling the glass.
(1) Adhesive
(2) 2 mm (0.08 in)
(3) Dam rubber
(4) Glass
GW-00071
(4)
(2)
(1)
(3)
(2) (2)
(3)
(1)
(1)
(3)
(B)
(A)
(A)
(C)
(4)
(C)
GW-00566
(1) Front reinforce side panel
(2) Seal
(3) Intersection point of front reinforce side panel
and front pillar out panel
(3)
(1)
(2)
(2)
GW-00560
asieps_tobira.book 19 ページ ２０１２年２月１０日 金曜日 午後３時２６分