STW TC1, Руководство пользователя

Страница: 309 / 374

9 Update the Device
User Manual 309/374
In this section the user can select the components of the BSP (see " BSP Components " on page 307) that have
to be updated.
;*******************************************************************************
; START OF USER SETTINGS. ***
; Do not make any changes to this file except in this section!!! ***
;*******************************************************************************
1. Open the config.ttl with an editor of your choice.
2. Select the COM port for the Windows Updater, where the TC1 is connected to the PC:
3. Set the update source:
a. Update via TFTP download: Set VarTftpDownload = 1
In case of an update via TFTP, the network settings of the config.ttl file needs to be completed (for
example: set the IP address, set the network mask).
b. Update via RS232 download: Set VarTftpDownload = 0. The Update via RS232 is not recommended,
because it will take a very long time.
4. Select the components that shall be updated:
a. Go to the sub section "Components to be installed". By default all components are set to 1 and will be
updated.
b. Set all components that must be updated to 1. Set each component to 0 when it is not needed to be
updated.
5. Save your settings and close the file.
The complete update procedure will be logged in a file. The default name of this log file is tc3g_updater.log.