36
Programming and installation manual Careline Anna / Careline GSM
Doc. no. 32-022-03-01 EN v6
External out
>Function<
Here you can determine what happens when you activate the relay.
<Phone activate>
used if you want to activate the relay via an alarm centre by pressing '9 'on a
mobile phone.
< Alarm relay>
In this mode , the relay will be activated whenever an active alarm is detected and the
Careline Anna/GSM call the alarm central. So the relay will be triggered whenever a medical alarm, fire
alarm, bed alarm, etc is generated. Technical alarms will not trigger the relay. The relay is activated the
green button.
<Ring Indicated>
used if you want to activate the relay when someone is calling.
<TX remote 1>
used to activate the relay by pressing twice on the Tx button. To manually deactivate
the relay press 3 times on the Tx button if the relay has been activated.
<TX remote 2>
used to toggle the relay by pressing twice on the Tx button. To manually deactivate
the relay press 3 times on the Tx button if the relay has been activated.
<Presence>
used to activate the relay when marking presence. When marking ready the external exit
relay will be deactivated.
<Alarm Receipt>
used to activate the relay when an alarm has been sent to an alarm receiver and has
been received by the alarm receiver.
<System Warning>
used to activate the relay when the function System Warning indicates that
something is wrong. For more information about the System Warning , see below.
>Activation time<
Determines how long the exit shall be activated.
External input
>External 1<
and
>External 2<
<
Normal open>
The external input is activated once closed.
<Normal closed>
The external input is activated once opened.
<Presence>
The external input is activated when there is a connection and sends a presence
indication to the alarm receiver.
<Ready>
The external input is activated when there is a connection and sends a ready indication to
the alarm receiver.
<Presence/Ready>
When closed a presence indication is sent. When the next closed is indicated a
ready indication is sent.
<Red button>
In this mode the external input has the same function as the red top button.
<Green button>
In this mode the external input has the same function as the green top button.
<Grey button>
In this mode the external input has the same function as the grey top button.
Other
> System Warning<
>Activation< >Warn. sources<
Once system warning is activated, the LEDs flash and/or a sound emanates from the speaker. Choose
<Visual>
<Acoustic> <Both>
or
<Not activated>
. The system warning indicates low battery, mains
failure or that the line has disappeared. By pressing the green reset button the audible warning is
stopped. The acoustic/visual warning can be programmed individually directly or independently via
the hand terminal. These signals only appear when Careline Anna/GSM is in normal mode. See light
signal table in Section 1.5.
Under
>Warn. sources<
you can define which of the following warnings the system warning should
indicate:
>Line failure<, >Mains failure<, >Acc failure<
and
>GSM failure<.
(The last-mentioned is
only available in Careline GSM.) For example should the line failure warning be deactivated when you
send all the alarms via GSM and no phone line is connected.
