Programming and installation manual Careline Anna / Careline GSM
Doc. no. 32-022-03-01 EN v6
4.2.6
Programming of number of attempts
If the carephone does not get through to transmit its alarm at the first attempt, it waits one minute and then
attempts again. Here you can set the number of attempts to be made for each number/address before
proceeding to the next step in the sequence. (See table in Appendix A.)
Follow the instructions below.
Choose
Attempts
, press
Yes
Choose
Number A
, press
Yes
Value
5
is the default value
Enter the desired number of attempts for the current number and press
Yes
. If you happen to mistype,
press
to delete.
Repeat the procedure for Numbers B, C and address a, b, etc. For each phone number and address specified
in Section 4.2.2 and 4.2.3 there should be a specified number of attempts. (5 is pre-programmed by
default.)
Press
No
to exit the menu Number of attempts .
4.2.7
Press No twice to leave the menu GSM functions .Programming of connection
If you have a Careline GSM, you can for the phone number you provided choose how to be called, i.e., if it is done
via the analogue line or via GSM. (See table in Appendix A.)
Follow the instructions below to change.
¨
Choose
Connect. type
, press
Yes
Choose
Number A,
press
Yes
Value
Tele line
has been preset
Choose the desired connection type by pressing
and
until the chosen connection type is shown under
New value , and then press
Yes
..
Repeat the procedure for Number B, C etc. For each phone number entered in section 4.2.2, a connection
type must be specified. (Tele line is pre-programmed by default.)
Press
No
to exit the menu Connection .
4.2.8
GSM settings
If the alarm is sent via GPRS, you have to change some settings for this connection.
Choose
GSM functions.
, press
Yes
Choose APN, press Yes
Enter the APN address. It can be numeric or with letters, and can contain max 48 characters.
Press
Yes
.
Alarm codes
Protocol
Sequences
>A
ttempts
<
ATTEMPTS
>
Number A
<
Number B
Number C
Value in HT:
5
New Value:
5
Protocol
Sequences
Attempts
>
Connect. type
<
CONNECT. TYPE
>
Number A
<
Number B
Number C
Value in HT:
<Tele line>
New Value:
<Wireless>
Plus Alarm
In/Output
Other
>GSM functions<
GSM FUNCTIONS
>APN<
Security
