Programming and installation manual Careline Anna / Careline GSM
Doc. no. 32-022-03-01 EN v6
3.4
Table for Sequences
When an alarm receiver does not respond to the call, the carephone can continue to call another alarm receiver.
The table contains information about in which sequence the carephone shall contact the programmed phone
numbers/addresses. This can vary between different alarm types (see Section 4.2.5). The Careline Anna/GSM has
increased both the number of sequences and the number of steps in each sequence. Now you can enter as many
as 8 sequences with 10 steps in each sequence.
Cascading means that the carephone can continue to call with a different sequence if it does not get an answer
on any of the attempts in the first sequence.
When the programming has been completed, it may look like the table below. Note that the secondary number
or address you choose to contact is not necessarily called by the carephone on the second attempt; it depends
on how many calls have been entered for the respective number/address (see Section 4.2.2 and 4.2.3). The
number listed in "Repeat sequence" is the number of times that the sequence is repeated, if the alarm does not
get answered. If the value 1 is set, it means that the sequence is run once. If the value 2 is specified, it means that
the sequence is run once and then repeated once. In the sequences the phone numbers are represented by
upper-case letters and the addresses by lower-case.
Fill in the values of your programming in the table in Appendix A.
1st
2nd 3rd
4th
5th
6th
7th
8th
9th
10th Cascading
Sequence 1
A
B
A
B
-
-
-
-
-
-
Sequence 2
Sequence 2
a
b
c
a
b
c
-
-
-
-
-
Sequence 3
C
C
C
C
c
c
c
c
-
-
Sequence 4
Sequence 4
D
d
D
d
e
-
-
-
-
-
-
Sequence 5
-
-
-
-
-
-
-
-
-
-
-
Sequence 6
-
-
-
-
-
-
-
-
-
-
-
Sequence 7
-
-
-
-
-
-
-
-
-
-
-
Sequence 8
-
-
-
-
-
-
-
-
-
-
-
Repetition of Sequence
2
4
Programming of the Hand Terminal
4.1
Introduction to the Hand Terminal
The carephone is programmed using a HT-III Hand terminal (see image 5), which connects to the back of the
carephone using the supplied red wire.
The text in the display will be shown
like this in the rest of the document.
Image 5. Hand terminal HT-III with a 4-row display and buttons
Connect
carephone
or press
for offline
