Programming and installation manual Careline Anna / Careline GSM
Doc. no. 32-022-03-01 EN v6
4.2.3
Programming of the address of the alarm recipient
If the carephone is the Careline GSM model, the alarm can be sent via GPRS. The Internet addresses of the alarm
receivers shall be entered, according to the instructions below:
Choose
Addresses
, press
Yes
.
Choose
Address A
, press
Yes
Enter the Internet address and port from the address table in Appendix A (may be in letters or numeric IP
address). Any symbols you may need are on the buttons 1 and 0. To switch between upper-case and
lower-case letters, press the *- button.
Maximum 48 characters (16 in each row).
To delete if you accidentally press wrong, press
.
Finish by pressing
Yes
.
Press
to the next address and repeat the procedure above to add the addresses B, C etc.
Press
No
to exit the menu "Addresses".
4.2.4
Programming of protocol
When sections 4.2.2 and/or 4.2.3 are finished, continue according to the below:
Choose
Protocol
, press
Yes
Choose
Protocol A
, press
Yes
Value
STT
has been acquired
Press
or
until the protocol is shown in the "new value" field and press
Yes
to accept.
Repeat the procedure for Protocol B, C etc. For each phone number entered in section 4.2.2, a protocol must
be specified. The protocol for the addresses are below the protocols for telephone numbers, but there is
the protocol STT IPACS default.
Press
No
to exit the menu "Protocol".
Alarm types
Location codes
Alarm codes
>
Protocol <
PROTOCOL
>
Protocol A
<
Protocol B
Protocol C
Value in HT:
<STT>
New Value:
<
STT
>
PROGRAM
Phone numbers
>
Addresses
<
Transmitters
ADDRESSES
>
Address a
<
Address b
Address c
Value in HT:
Value in HT:
111.10.35.45:100
00
