Programming and installation manual Careline Anna / Careline GSM
Doc. no. 32-022-03-01 EN v6
2.5
Wall Mounting
If the carephone is to be mounted on the wall, you can choose which way it should be mounted. Then press out
the cover for the selected holes. The distance between holes is about 110 mm and 42 mm. It can be beneficial to
use the back cover of the carephone as a template when you mark where to place the screws. Use screws with
heads that fit the holes so that the carephone can easily be hung up and lifted off when necessary.
2.6
After Completed Installation
After the basic programming, installation and programming of the alarm transmitter has been completed, carry
out a function test.
Carry out a range test (see instructions in Section 5.2.5)
Try to send an alarm. If the alarm is to go via the analogue telephone line
and via GSM - be sure to try both.
Note! The back cover of the carephone should be on to ensure the best sound quality!
3
Programming Structure
This section helps you to structure the values to be inserted into the hand terminal, which is then used to
program the carephone. Read through it and then fill in the corresponding tables in Appendix A at the end of this
manual. The completed tables facilitate the programming of the hand terminal.
3.1
Table of Alarm Receiver Telephone Numbers
In order for Careline Anna/GSM to transfer an alarm to an alarm recipient via an analogue telephone line or GSM
connection, it is necessary to program it with the following information:
Phone number to the alarm receiver (or receivers if there are more than one)
Protocol, i.e., which transfer method is to be used, such as STT, CPC, etc.
Alarm code that tells the alarm receiver from which carephone the alarm has been sent
Number of attempts the carephone shall make to the different alarm telephone numbers.
If the communication is to go via analogue or via GSM.
When the user programming has been completed, it may look like the table below. Fill in the values of your
programming in the table in Appendix A.
Number
Telephone no.
Protocol
Alarm code ¹
No of attempts
Connection²
A
0406252500
STT
1234
3
Telephone line
B
0406252500
STT
1234
3
Wireless
C
0406252550
STT
1234
3
Telephone line
D
020223242
STT
111234
5
Wireless
E
-
-
-
-
-
F
-
-
-
-
-
G
-
-
-
-
-
H
-
-
-
-
-
I
-
-
-
-
-
J
-
-
-
-
-
N (Nightmode) 020223242
STT
123456
5
Wireless
V (Forwarding) -
-
-
-
-
1)
The alarm codes need only be entered if the alarm is to be sent with different alarm codes to the various
alarm receivers.
2)
Only available if the carephone has GSM functionality.
Note! Note that if you want to call the same number first over the telephone line and then wireless via GSM (or
vice versa) you must enter this number twice (see code A and code B) and specify the different connection types.
