Programming and installation manual Careline Anna / Careline GSM
Doc. no. 32-022-03-01 EN v6
Transmitter number
Name (default in hand terminal)
Transmitter 1
Medical
Transmitter 2
Medical
Transmitter 3
Medical
Transmitter 4
Fire
Transmitter 5 *
Door alarm
Transmitter 6 *
Bed alarm
Transmitter 7 *
Carpet alarm
Transmitter 8
Passive. (Remember to change the time if the alarm it to be sent immediately.
This is done in the Hand terminal under >
Time Alarm
< and then >
Passive
Alarm
<. Enter
0
and send the value by holding the right arrow button for a few
seconds until <
send value
> is displayed.)
Transmitters 9 16
Medical
* Only works if your alarm receiver can handle these types of alarms.
5.2
Programming via buttons on the top of the carephone
Many of the basic functions can be operated via buttons on the top of the carephone. In section 1.4 there is a list
of these functions.
5.2.1
List of functions in programming mode
Here is how to enter the programming mode and how to access the functions contained in the programming
mode.
To enter the programming mode:
Hold the green button down, press the grey and red. Release on audio signal.
Function
Control
Set the speaker volume
Hold down grey, release after 1 beep. Then press grey to decrease, red to
increase, green to save. There are 8 levels, 1-8 beeps. (See section 5.2.4.)
Set LED brightness
Hold down grey, release after 2 beeps. Then press grey to decrease, red to
increase and green to save. There are 10 levels, 1-10 beeps.
Activate range test
Hold down the grey, release after 3 beeps.
Start teleprog. after 1 signal
Hold down the grey, release after 7 beeps.
Program alarm transmitter
Hold down the red, release after the number of beeps corresponding to
the transmitter position you want to use. Activate the alarm transmitter to
be programmed. (See section 5.2.2.)
Deprogram alarm transmitter
Hold down red, release after the number of beeps corresponding to the
transmitting position you want to deprogram. Press the grey button. (See
section 5.2.3.)
To exit the programming mode
Press the green button. The LED should be solid green when the carephone is in normal mode.
