32
Programming and installation manual Careline Anna / Careline GSM
Doc. no. 32-022-03-01 EN v6
Cascading
Here you can choose the order of the sequences. If, for example, under
>Sequence 1<
you choose
<Sequence 3>
, then an alarm that is set to call according to sequence 1 shall continue to call as sequence
3 when all attempts to sequence 1 is completed. You cannot create a loop by referring sequence 1 to
sequence 2 and sequence 2 to sequence 1. However, if you chose to repeat sequences, they will run
several times. Maximum of 40 attempts can be made in total (100 attempts for the alarm type Plus Alarm).
>Sequence 1<
to
>Sequence 8<
Repeat. sequence
In this menu, specify how many times the sequences shall run. The value can be set between 1 and 9, the
factory default is 1. Note that the value applies to all four sequences. Max 40 attempts in total is possible.
Demand disconnection
In this menu choose what Careline Anna/GSM should do if the call does not disconnect properly, but
speech communication has been established.
Choose
<Yes>
Careline Anna/GSM will call again.
Choose
<No>
Careline Anna/GSM will not call again. The default value is <No>.
Note! If you receive alerts in STT Mobile alarm, the above set-up requiring disconnection will not be valid.
There the alarm is disconnected even if speech communication has been disconnected as a member of
staff has opted to take it, and therefore has the responsibility for this alarm.
Attempts
Has a submenu where you can specify how many attempts Careline Anna/GSM shall make to contact the
alarm receiver on the respective phone number/address.
>Number A<
to
>Number J< >Nightmode N< >Temp redir. V< >Address a<
to
> Address h<
>Nightmode n< >Temp redir. v<
You can enter values between 1 and 9. If you enter values greater than 9, Careline Anna/GSM will still not
make more than 9 attempts. The default value is 5. Remember that an attempt may take from several
minutes (depending on whether the carephone reaches the alarm receiver or not) so there should not be
too many attempts on the primary number.
Connection type
This menu is only available in Careline GSM and has a submenu where for each phone number and
address you can specify the type of connection used.
>Number A<
to
>Number J< >Nightmode N< >Temp redir. V< >Address a<
to
> Address h<
>Nightmode n< >Temp redir. v<
On the phone numbers you can specify whether the alarm is to call via the
<Tele line>
or
<Wireless>.
For
the addresses, you can in the Careline GSM only enter <Wireless>, as this communication goes over GPRS.
Outgoing call
Has a submenu, which controls functions that are used when the carephone is dialling.
>Precall signal< >Dial tone detection< >Mute dialling< Polarity change<
Precall signal
Determines what type of signal is heard in the loudspeaker on the Careline Anna/GSM when a medical
alarm is activated. The menu is multiple-choice <
Type 1> <Type 2> <Type 3> <Type 4>
and
<Not
activated>
. The factory default is
<Type 1>.
