BM49
1680
Rear Mount
1601
Body
Pan
AH Bolt (6) &
JJ Nut (6)
1680
Rear Mount
“tab”
NOTE:
STEP 1 [below] may have al-
ready been completed at the Factory...
if so, go on to STEP 2. below.
STEP 1.
Align the six (6) 3/8”
Holes in #1680 Rear Mount with mating
six (6) 3/8” Holes in
rear surface
of
#1601 Body Pan.
From
outside,
insert a #AH Bolt
into each of the six 3/8” holes aligned
above.
Inside
Body, secure Bolts with
#JJ Nuts... tighten... see Photo at right.
STEP 2.
Slip “arms” of #1693
Bail around “sides” of #1680 Hitch
Channel.
STEP 3.
Align either the
lower
or upper
1/2” holes in #1693 Bail
“arms” with mating 5/8” holes in “sides”
of #1680 Channel.
NOTE:
You can experiment with the
two hole positions
to “fine tune” the
Rear Hitch rasing & lowering character-
istics to the job you’re doing.
From
outside,
insert an #AE
Bolt into each pair of
aligned
1/2” and
5/8” holes
above
. Over each protruding
Bolt slip on in order: #1701 Bushing,
#VV Washer and secure with #II Nut...
tighten.
STEP 4.
Inside #1693 Bail
chan-
nel,
screw an #AI Bolt into each Nut
welded inside
... let 1/2” protrude out
rearward [You are doing this to store
the #AL Bolts for future use]... see
Photo at right.
AE
II
VV
1701
II
1680
Rear Mount “sides”
(from PP35)
1693 Bail
“channel”
1693
“arms”
1693
“plate”
AI Bolt
1693 Bail
“channel”
