Objet260 User Guide
6 Operating and Maintaining the Objet260 3D Printer
DOC-37004 Rev. E
6-67
If the UV level measured is not acceptable, the wizard calibrates the UV lamp
by adjusting the current supplied to it, and then tests it again.
When all UV tests have finished, the results are displayed, showing the
condition of the lamps after calibration (see Figure 6-100 below).
Figure 6-100 Results and condition of UV lamps after calibration
After examining the UV calibration results:
1. Click
Next
.
2. Remove the UV sensor and close the printer cover. After confirming the
items listed in the wizard screen, click
Next
.
Figure 6-101 Final UV Calibration Wizard screen
