Objet260 User Guide
6 Operating and Maintaining the Objet260 3D Printer
DOC-37004 Rev. E
6-10
Resuming Production After Printing has Stopped
If the printing process is interrupted, Job Manager stops sending slices to the
printer. This can happen, for example, if the printing material runs out in the
middle of a print job, and you do not replace the empty cartridge immediately.
After the printer changes to
Standby
or
Idle
mode, you need to resume
printing from the
Job Manager
screen of Objet Studio.
After printing stops, the printer goes into
Standby
mode, when heating of
the print heads is reduced. About 10 hours later, the printer goes into
Idle
mode, when heating of the print heads is stopped.
To continue printing the model:
1. If the printer is in offline mode, switch it to online mode by clicking the
red button at the bottom of the printer interface (see Figure 6-3 on page
6-4).
The button changes from red to green (see Figure 6-3 on page 6-4).
2. If you don’t know why printing has stopped, make sure that the
connection between the printer and the server computer is active.
3. In the
Job Manager
screen of Objet Studio, click the
Resume
icon
.
4. In the
Continue from Slice
dialog box that appears, confirm the slice
number, after checking the printer interface.
Figure 6-6 Printer interface after interrupted printing
Figure 6-7
Continue from Slice
