Objet260 User Guide
6 Operating and Maintaining the Objet260 3D Printer
DOC-37004 Rev. E
6-57
Installing the New Head
15. Inspect the replacement head, and make sure that the O-ring seals are in
place (see Figure 6-77 on the previous page).
16. Gently insert the replacement head into the vacant slot in the print block,
and push the print-head driver card into its socket.
Note:
Make sure to insert the head with the driver card facing its socket, in the
rear of the print block.
Figure 6-79 Inserting the print-head driver card into its socket
17. Push the head up until you hear it click into place, in both front and rear
holders.
Figure 6-80 Pushing the head into place in the print block
18. Lower the door of the print head compartment, and tighten the screws to
lock it in place.
19. Tighten the upper and lower screws that secure the print head in the print
block (see Figure 6-73 on page 6-54).
Note:
Hand-tighten these screws. Do
not
use a screwdriver.
