Spectracom NetClock 9400 Series, Руководство пользователя

Страница: 64 / 467

5.
Press the key once to select the action, then again to apply it.
B.
Enter IP Address and Subnet Mask :
1. Still on the
Home > Netv4 > eth[0-3]
menu, select
IP Address
, and
change "
N=010.010.201.001/16
” to the value of the static IP address and
subnet mask/network bits to be assigned (for a list of subnet mask values refer to
the table "Subnet mask values" on page 53).
2.
Press the key once to enter the setting, then again to apply the new setting.
C.
Enter the Gateway Address (if required)
1.
Still on the
Home > Netv4
menu, select the
Gateway
option (
Home >
Netv4 > eth0 > Gateway
).
2.
Press the key once to enter the setting, then again to apply the new setting.
3.
The display will change, allowing you to input an address at
N=000.000.000.001. Enter the gateway address here. The address entered must
correspond to the same network IP address assigned to NetClock.
D.
Enable/disable the Port (if required)
1. Still on the
Home > Netv4
menu, select the
eth[X]
port that you want to
enable or disable.
Note: By default,
eth0
is enabled, while all other ports are dis
abled.
2. Navigate to the
Port
option (
Home > Netv4 > eth0 > Port
).
3.
Press the
˄ ˅
arrow keys once to change between Enable and Disable.
After all applicable settings have been updated, press the key three times to return to the
main display. It should now resemble the following example:
48
CHAPTER
2
•
NetClock User Reference Guide Rev. 16
2.11 Setting up an IP Address