Note:
While GPS Notification Alarms can be used in
Mobile GNSS Receiver
Mode
, it is not advisable.
To determine which
GNSS Receiver Mode
your NetClock is using, see "Selecting a GNSS
Receiver Mode" on page 189.
To determine
how many satellites
your NetClock unit is currently receiving, navigate to
INTERFACES > REFERENCES: GNSS 0
. See also "Reviewing the GNSS Reference Status" on
page 183.
To
set
the GPS Alarm Thresholds:
1.
Navigate to
MANAGEMENT > OTHER: Notifications
, and choose the
GPS
tab.
2.
At the bottom of the window, locate the
ALARM THRESHOLD
panel:
3.
In the
Minimum Satellites
fields enter the minimum number of satellites that must be avail
able before the alarm is triggered. The alarm will be triggered when the number of satel
lites available is
BELOW
this number.
4.
In the
Duration Below Threshold (s)
fields, enter the time
in seconds
that the system must
be below the threshold set in the
Minimum Satellites
field before an alarm is triggered.
The alarm will be triggered when this time is reached.
By default, this timeout value is set to 0 seconds: As soon as the receiver drops below the
minimum number of satellites, the associated alarm is triggered. A delay of e.g., 5
seconds, however, would not trigger an alarm if the number of received satellites drops
below the specified number for only 3 seconds.
You can configure this event to cause either a Minor alarm, or a Major alarm, or both.
To learn more about Minor and Major alarms, see "Minor and Major Alarms" on page 325.
Note that the GNSS receiver must initially be tracking more than the configured number of satel
lites in order for this alarm to be triggered (the alarm is triggered when the receiver falls below
the number of
Minimum Satellites
you specified above).
4.2.4
Setting Up SNMP Notifications
SNMP Notifications are SNMP traps that occur on a change of a monitored event.
To configure SNMP notifications:
232
CHAPTER
4
•
NetClock User Reference Guide
Rev.
16
4.2 Notifications
Содержание NetClock 9400 Series
