Note:
Users with “administrative rights” can perform all available com
mands. Users with “user” permissions only can perform
get
commands to
retrieve data, but cannot perform any
set
commands or change/reset
any passwords.
3.
Disable DHCP, type:
dhcp4set 0 off
<Enter>.
Note:
If your NetClock is configured with an Ethernet option card, use 0,
1, 2, 3 for eth0 – eth3.
Note:
For a list of CLI commands, type
helpcli
, or see
"CLI Commands"
on page 382
.
4.
Configure the IP address, subnet mask, and gateway (if needed):
ip4set 0 x.x.x.x y.y.y.y
<Enter>
(where
0
is the desired interface, “
x.x.x.x
” is the desired IP address for NetC
lock, and “
y.y.y.y
” is the full subnet mask for the network (For a list of subnet
mask values, see "Subnet Mask Values" on page 53.)
Enter
gw4set 0 gw_address
, using your gateway address
gw_address
.
5.
Once you have configured NetClock's IP address, you can login to the Web UI by enter
ing the new address into a web browser‘s address bar.
Setting Up an IP Address via Ethernet Cable
Note:
You may use an Ethernet crossover cable, but you do not have to.
Turn on the unit with NO cable plugged into the Ethernet port yet (Note: once you apply
power, it may take up to two minutes for the system to fully boot).
Configure your PC‘s network interface card (NIC) with an IP address on the same network as
the NetClock 9489‘s default IP address (
10.10.201.1
). For example, configure the IP
address of your PC‘s network interface card as
10.10.201.10
, with a subnet mask of
255.255.255.0
.
Connect an Ethernet cable from your PC to the Ethernet port of the NetClock unit. Once con
nected via crossover cable, open a web browser and enter the NetClock‘s default IP address
(
10.10.201.1
) into the browser‘s address bar and login to the NetClock‘s Web UI as an
administrator. Once logged in, network settings for the NetClock can be configured under
MANAGEMENT > Network Setup > Actions: General Settings
and under
Ports:
GEAR button.
46
CHAPTER
2
•
NetClock User Reference Guide
Rev.
16
2.11 Setting up an IP Address
Содержание NetClock 9400 Series
