Sony XDCAM PDW-HD1500, Руководство по обслуживанию

Страница: 119 / 160

PDW-HD1500/V1 (E)
6-21
6-12-3. NET-4 Board
Removal
1. Remove the top panel assembly.
(Refer to Section 1-4-1.)
2. Turn the PDW-HD1500 upside down.
3. Remove the rear panel, and remove the
bottom plate assembly.
(Refer to Section 1-4-3 and 1-4-4.)
4. Disconnect the IF harness from the connector
CN2 of the IF-1073 board.
5. (In the same way as other boards) insert tip of
Phillips head screwdrivers into cut-outs at the
right end and left end of the board to push the
mounted board out of slot.
6. Pull out the NET-4 board in the direction of
the arrow.
7. Disconnect the harness from the connector
CN100.
CN100
CN2
IF harness
NET-4 board
IF-1073 board
6-12-2. RX-93H Board, VPR-99 Board
Removal
VPR-99 board
RX-93H board
PSW2.6
x
5
PS3
x
5
M2
x
5
CN500 (red)
CN101
CN100
CN100
CN503 (blue)
CN502 (white)
Coaxial cable
assembly
CN101
Reinstallation
1. Reinstall the removed parts by reversing
steps 1 to 7 above.
Reinstallation
1. Reinstall the removed parts by reversing
steps 1 to 4 above.
1. Remove the top panel assembly.
(Refer to Section 1-4-1.)
2. Remove the rear panel.
(Refer to Section 1-4-3.)
3. Pull out the RX-93H board and the VPR-99
board in the arrow direction as follows:
Insert tip of Phillips head screwdrivers into
cut-outs at the right end and left end of the
board to push the mounted board out of slot.
4. Remove the four screws, and disconnect the
three coaxial cables from the connectors
CN500, CN502 and CN503, to detach the
RX-93H board.
n
When reinstalling the board, couple the two
connectors securely.
5. Remove the two screws to detach the coaxial
cable assembly.