Sony XDCAM PDW-HD1500, Руководство по обслуживанию

Страница: 112 / 160

6-14
PDW-HD1500/V1 (E)
Reinstallation
1. Press the die-cast bed of the optical block
assembly so that the optical block assembly is
moved to the position shown in the figure.
2. Align the upper and lower holes of the OP
rack assembly while pressing the both ends of
the OP rack assembly, and insert the parallel
pin into the holes.
3. Install the No.2 gear A onto the base plate
shaft.
4. Align the upper and lower holes of the No.3
gear assembly A while turning the No.3 gear
assembly A, and insert the parallel pin into
the holes.
5. Install the No.3 gear assembly A onto the
base plate shaft.
n
Install the No.3 gear assembly A so that the
gear of the No.3 gear assembly A is properly
engaged with the gear of the OP rack assem-
bly and with the No.2 gear A.
6. Attach two new stopper washers to the two
shafts of the base plate.
7. Pull out the two parallel pins.
8. Press the die-cast bed or the connector of the
optical block assembly, and check the
followings:
.
The optical block assembly moves smooth-
ly.
.
The OP rack assembly and the No.3 gear
assembly A are properly engaged.
n
For installation of the optical block assembly B,
refer to the installation procedure of the optical
block assembly A.
Optical block
assembly
OP rack assembly
Shaft
Stopper washer
No.3 gear assembly A
No.3 gear assembly B
No.2 gear A
No.2 gear assembly B
Stopper washer
Parallel pin
Parallel pin