Smiths Medical 1850, Руководство по эксплуатации

Страница: 58 / 82

Chapter 7: Printer
7-6 Oximeter Clinician’s Operation Manual
Printing Trend Data
Figure 7-4: Printing
Trend Data
1. Set up the monitor and printer as previ-
ously described.
2. Disconnect the SpO
2
sensor from the
monitor.
3. Connect the printer cable to the monitor.
4. Turn on the printer.
5. Turn on the monitor. The monitor prints
the trend data for each patient, from
patients 1-99, as shown in the sample
printout.
6. If there is no trend data at all, the mes-
sage “*******” is printed.
7. If no valid data is collected for a patient
number, “****” is printed.
8. If valid data is collected for a patient
number for less than one minute, only
the last measurement is printed.
9. If data is collected for a patient number
for more than one minute, the relative
time since the first measurement is
shown for that patient.
10. Dashes indicate invalid or unavailable data (for example, the
patient’s finger was removed from the SpO
2
sensor).
11. Pressing the I.D./CLEAR key increments the patient number, and
trend data is collected for the new patient number.
NOTE! If unexpected characters or question marks are printed,
turn the printer off and on to reset the printer.