Smiths Medical 1850, Руководство по эксплуатации

Страница: 52 / 82

Chapter 6: Patient Numbers and Trend Data
6-2 Oximeter Clinician’s Operation Manual
a. The middle two pulse bars flash., indicating the monitor is in
“trend view” mode. The two pulse bars continue to flash
until the mode is exited.
b. The current patient number is shown for a few seconds.
c.
The last valid data for the corresponding patient number is
shown in the SpO
2
and pulse rate displays. If no valid data
was collected, “– – –” is shown.
d. Pressing the or keys will increase or decrease the
patient number; the patient number will be shown for a few
seconds then the last valid data corresponding to the
patient number will be shown.
e. To exit the “trend view” mode, press the I.D./CLEAR key.
NOTE! If no keys are pressed for 20 seconds, the monitor auto-
matically exits the “trend view” mode.
Clearing Trend Data
1. The SpO
2
sensor must be connected to the monitor. If necessary,
connect the SpO
2
sensor to the monitor.
2. Press and hold the I.D./CLEAR key for about six seconds. While you
are holding the I.D./CLEAR key, the message
[{r
flashes on the dis-
play to tell you the trend data for all patients is about to be cleared.
When the trend data is cleared, the display shows
P1
.