Ski-Doo 2005 MACH Z, Руководство по ремонту

Страница: 207 / 343

Section 06 DRIVE SYSTEM
Subsection 02 (DRIVE PULLEY)
CAUTION: Ensure rollers are in good condition.
Replace as required.
Lever Bolt and Flanged Bushing
Check the flanged bushing no. 18 for wear. Re-
place if necessary.
Check lever bolts no. 19 for wear, replace as re-
quired.
O-ring and Slider Shoe
Check if O-rings no. 20 are cracked, cut or
crushed. Replace as required.
Check slider shoes no. 9 for wear. Replace if
groove is not apparent on top.
Sliding Half and Spring Cover Bushings
Visually inspect coating of bushings no. 14 and
no. 15 . Replace if worn.
Sliding Half Bushing Replacement
NOTE: In case of worn out bushing, it is advisable
to replace whole sliding half assembly as replac-
ing just the bushing may reduce the drive pulley
performance.
Remove circlip no. 21 from the sliding half.
A32D2TA
1
TYPICAL
1. Circlip
Secure the spring compressor (P/N 529 035 524)
in a vice. Mount the bushing remover/installer
(P/N 529 031 200) and the sliding half assembly
on it.
A32D2UA
529 031 200
529 035 524
TYPICAL
Use the sliding half bushing remover/installer
(P/N 529 035 931) to press out old bushing.
NOTE: Make sure to use the tool as marked; to
remove the bushing press using the side marked
“OUT”, as shown below in the picture.
A32D2VA
TYPICAL
Use a soft sand paper to clean sliding half bushing
mounting surface.
194
mmr2005-132