Ski-Doo 2005 MACH Z, Руководство по ремонту

Страница: 187 / 343

Section 05 ELECTRICAL SYSTEM
Subsection 03 (STARTING SYSTEM)
Volt
A35E0AA
– Crank engine and record the result.
– The voltage reading should not exceed 0.2 volt.
If the result is over 0.2 volt, the solenoid is de-
fective or there is a bad connection.
TEST 3
– Place the positive probe of multimeter to the
output terminal of solenoid and the negative
probe to the starter positive terminal.
A35E0BA
Volt
– Crank engine and record the result.
– The voltage reading should not exceed 0.2 volt.
If the result is over 0.2 volt, verify connections
and wire condition.
TEST 4
– Measure voltage to starter. Place the positive
probe to the starter positive terminal and the
negative probe to the starter housing.
Volt
A35E0CA
– Crank engine and record the result.
– The voltage reading should not drop below
9 volts. If the result is under 9 volts, the starter
is defective or there is a bad connection.
TEST 5
– Place the positive probe to the starter housing
and the negative probe to negative battery ter-
minal.
Volt
A35E0DA
– Crank engine and record the result.
– The voltage reading should not exceed 0.2 volt.
If the result is over 0.2 volt, verify connections
and battery/engine ground wire conditions.
Electric Starter
Remove the tuned pipe and disconnect spark plug
cables.
Using booster cables, carefully supply current
from the battery directly to the starter. Connect
the BLACK cable first to the ground. Connect the
other booster cable from the battery to the starter
positive terminal.
mmr2005-129
173