Ski-Doo 2005 MACH Z, Руководство по ремонту, Страница: 283 / 343

Section 07 REAR SUSPENSION
Subsection 03 (SHOCK ABSORBER INSPECTION AND SERVICING)
A32F1WA
4
1
2
3
1. Damper nut
2. Spacer
3. Stopper with its round edge facing nut
4. Shim pack
CAUTION: The damper rod nut can only be
reused 4 times, then, must be replaced. Do
not substitute this part for non - O.E.M. Use
Loctite 271 on nut each time.
This (these) spacer washer(s) must be used as
shown to ensure damper rod nut does not bottom
out or contact shaft threads.
Rebound valve stopper with round edge facing
nut.
NOTE: Rebound shim stack must not reach into
threads of damper shaft. Spacer under damper
shaft nut is used to prevent damper shaft nut from
bottoming on threads.
A32F1XA
1
2
3
4
5
6
1. Rebound dampening shim pack
2. Rebound dampening shim pack
3. Piston
4. Compression dampening shim pack
5. Compression dampening shim pack
6. Stopper
If the seal carrier assembly is replaced, use seal
pilot to guide seal over damper shaft. Lubricate
seal carrier guide pilot before use.
CAUTION: Failure to use seal pilot will result in
seal damage.
Reassemble damper rod assembly, taking care to
properly assemble shim packs as required for your
dampening needs. Ensure that the shaft piston
is installed with the slits/larger intake holes facing
the rebound shim stack.
A06F12C
1
1. Seal guide
mmr2005-140
273