Ski-Doo 2005 MACH Z, Руководство по ремонту, Страница: 309 / 343

Section 08 STEERING/FRONT SUSPENSION
Subsection 02 (FRONT SUSPENSION)
1
A33F27B
TYPICAL
1. Tab here to obstruct access hole
Upper Arm
When installing ball joint no. 15 to upper arm, en-
sure to tilt it with the proper angle as shown. The
ball joint housing must be parallel to ski leg tab.
This mounting position corresponds to 10° ± 3°
angle from upper arm.
10° ± 3°
A33F2IB
Lower Arm
Position lower arm below anti-sway bar.
Prior to installing ball joint in lower arm, ensure to
clean the tapered surfaces with the pulley flange
cleaner (P/N 413 711 809). Surface contacts must
be clean and free of dirt, oil and grease. Apply
the cleaner on a rag then use the rag to clean the
surfaces of ball joint and ski leg.
To install ball joint, proceed as follows:
– Install ball joint support (P/N 529 035 875) on
top side of lower arm (operating position).
– Position ball joint installer (P/N 529 035 975) on
bottom side of lower arm (operating position).
– Press ball joint in.
– Install snap ring
no. 13 with its opening toward
front of vehicle.
529 035 975
A33F29B
529 035 875
To properly torque ball joint nut, use the A-arm nut
wrench (P/N 529 035 876).
529 035 876
A33F2AA
Ensure to install the tool perpendicularly (90°) to
torque wrench.
mmr2005-142
301