Ski-Doo 2005 MACH Z, Руководство по ремонту, Страница: 32 / 343

Section 01 MAINTENANCE
Subsection 03 (PRESEASON PREPARATION)
PRESEASON PREPARATION
SERVICE PRODUCTS
Description Part Number Page
pulley flange cleaner............................................................. 413 711 809 ......................................... 7–8
XP-S synthetic chaincase oil ................................................. 413 803 300 ............................................. 8
Proper vehicle preparation is necessary after the
summer months or when a vehicle has not been
used for more than one month.
Refer to preseason preparation column from
MAINTENANCE CHART jointly with the present
preseason preparation procedure in order to cover
each and every aspect of the snowmobile presea-
son preparation procedure.
Any worn, broken or damaged parts found during
the storage procedure should have been replaced.
If not, proceed with the replacement.

WARNING
Unless otherwise specified, engine should be
turned off for preparation procedure.
ENGINE
Rags in Air Intake and Exhaust System
Remove rags that were installed during STORAGE
preparation.
Rewind Starter and Rope
Check if rope is fraying, replace if so.
When pulling starter grip, it must return freely. If
not, check for damaged parts or lack of lubrication.
Replace parts or lubricate accordingly.
Cooling System
Inspect cooling system for leaks, to perform a
cooling system leak test, refer to ENGINE section.
Check coolant level in coolant reservoir. Add
coolant if necessary.
If engine is cold, refill up to 15 mm (5/8 in) over
COLD level line.
If engine is hot, refill up to 25 mm (1 in) over COLD
level line.
Oil Injection Pump
Make sure oil injection pump is properly adjusted,
refer to ENGINE section.
FUEL SYSTEM
Fuel Filter
Replace fuel filter, refer to FUEL SYSTEM section.
Fuel Lines, Fuel Rails and Connections
Inspect fuel system for leaks, to perform a fuel
system pressurization, refer to FUEL SYSTEM.
Throttle Cable
Make sure that throttle cable operate freely, re-
place if necessary, refer to ENGINE MANAGE-
MENT SYSTEM.
Air Filter/Air Intake System
Check that inside of air silencer is clean and dry
then properly reinstall the filter, refer to ENGINE
SYSTEM.
CAUTION: These snowmobiles have been cal-
ibrated with the filter installed. Operating the
snowmobile without it, may cause engine dam-
age.
Throttle Body
Remove the throttle body from vehicle.
Using the pulley flange cleaner (P/N 413 711 809),
remove the dirt ejected by the drive belt from the
throttle plate and from both throttle body bores.
After throttle body installation, adjust throttle and
injection oil cables.
mmr2005-112
7