Siemens SINAMICS S150, Руководство по эксплуатации

Страница: 154 / 520

Commissioning
5.3 Procedure for commissioning via STARTER
Drive converter cabinet units
154
Operating Instructions, 07/07, A5E00288214A
Results of the previous steps
● You have created a drive unit project offline using STARTER.
● You have saved the project data to the hard disk on your PC.
● You have transferred the project data to the drive unit.
● You have saved the project data to the CompactFlash card so that it is protected in the
event of a power failure.
Note
The STARTER commissioning tool supports complex drive system operations.
If you are confronted with any system conditions in online mode that are beyond your
control, you are advised to delete the drive project from the project navigator and
carefully create a new project in STARTER using the appropriate configuration data for
your application.
5.3.4 Connection via serial interface
In addition to using the PROFIBUS connection, data can also be exchanged via a serial
interface.
Prerequisites
The PC from which the connection is to be made must be equipped with a serial interface
(COM).
Settings
1. In STARTER, choose Project > Set PC/PG interface and select the serial cable (PPI)
interface.
If this is not available from the dropdown list, you first have to add it by choosing Select.
Note
If the interface cannot be added to the selection menu, the driver for the serial interface
has to be installed.
This is located under the following path on the STARTER CD:
\installation\starter\starter\Disk1\SerialCable_PPI\
STARTER must not be active while the driver is being installed.
2. Make the following settings. The "0" address and the transmission rate of 19.2 kbit/s are
important here.