Siemens SINAMICS G110M, Руководство по эксплуатации, Страница: 46 / 428

4.2.2 Disassembly
Procedure
When the SINAMICS G110M is delivered as separate components, the Terminal Housing must be
fitted to the motor. To accomplish this task it is necessary to disassemble the Terminal Housing
to gain access to the motor mounting fixtures in the base of the Terminal Housing.
To disassemble the Terminal Housing, the following procedure should be performed.
1. Remove the Communications & Power Interface (CPI)
1. Remove the CPI ribbon cable from the Control Module.
2. Unscrew the four screws holding the CPI in place on the Ter‐
minal Housing.
Notes:
• The CPI ribbon cable is permanently attached to the CPI board
and therefore no attempt should be made to remove it from
the CPI board.
• The seal on the Terminal Housing behind the CPI is a moulded
seal and no attempt to remove them from the Terminal Hous‐
ing should be made, as this would permanently damage the
seal and significantly reduce the IP rating of the Terminal
Housing.
2. Remove the blanking plate
1. Unscrew the four screws holding the blanking plate in place
on the Terminal Housing.
2. Do not try and remove the seal on the Terminal Housing.
Note:
The seal on the Terminal Housing behind the blanking plate is a
moulded seal and no attempt to remove them from the Terminal
Housing should be made, as this would permanently damage
the seal and significantly reduce the IP rating of the Terminal
Housing.
3. Remove the Control Module
1. Unscrew the four self-retaining screws that secure the Con‐
trol Module in place.
2. Carefully lift the Control Module out of the Terminal Housing.
Note:
The screws that secure the Control Module in place are self-re‐
taining screws and cannot be fully removed from the Control
Module casing.
Installation
4.2 System Installation
Distributed converter for SIMOGEAR geared motors
44
Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL