101
FLD-1 Real-Time Dust Monitor Problem Report Form
If a problem occurs, please photocopy and fill out this Problem Report Form and contact your Sibata
representative or the distributor where the product was purchased.
Date Completed:
Circumstances Under Which the Product Is Used
•
Serial No.:
•
Purchase date:
•
Initial use date:
•
Frequency of use:
Daily
__ days a week
__ days a month
•
Hours used per day:
24 hours per day (continuously)
__ hours
•
Installation site:
•
Ambient temperature at installation site: Between __ and __
°
C
Note: If possible, indicate an actually measured value.
•
Use of optional PM2.5 cyclone selector:
Yes
No
•
Number of units owned: __ units
•
Number of units with problem: __ units
Description of Problem
•
When problem occurred:
Immediately after purchase
Within 1 month
Within 1 week
Other*
* Describe what preceded problem and other factors.
•
Problem frequency:
Daily
Occasionally
Rarely
Other*
* Explain, such as "whenever __ occurs":
•
Symptoms (in as much detail and as specifically as possible):
Check List
•
Does the unit show any signs of being dropped or impacted?
Yes
No
•
Was the unit located near salt water or hot springs?
Yes
No
•
How dirty was the filter?
Quite dirty
Not very dirty
•
Does the screen illuminate when the power is switched ON?
Yes
No
•
Does the pump operate during measurements?
Yes
No
Not sure
•
How many hours has the pump been operated?
__ hours (See page 63.)
•
Did the BG measurement and sensitivity adjustment processes finish normally?
Yes
No, "CALIBRATION FAIL!" is displayed.
If there is a possibility the product may have captured any hazardous substances, be sure to indicate that.
(Copy and use this page.)
