Segway S301000-20100A, Руководство по обслуживанию

Страница: 35 / 407

2 - 20
MAINTENANCE
Check and replace the demand drive fl uid at intervals in
the periodic maintenance diagram.
!
CAUTION
If the front gearbox makes too much noise during 4WD
operation, change the demand drive fluid.If the noise
continues, please check the service of your dealer or
other qualifi ed service facility.
Use the recommended oil.Use of other liquids may result
in improper unit operation. Maintain liquid level at bottom
of fi lling hole thread.
Check the level of rear gear box
【
A
】
Rear axle gearbox
【
B
】
Oil dipstick
【
C
】
Upper reticle
【 D 】 Undercut
1. Park the vehicle on the level ground.The engine
warmer should wait at least fi ve minutes to allow the
oil to fl ow back to the bottom of the engine.
2. Place a piece of cotton cloth under the end of the oil
ruler and pull out the oil ruler.
3. Wipe the oil ruler clean.
4. Re-insert completely;
5. Put a piece of cotton cloth under the end of the oil
ruler, then pull out the oil ruler and check the oil level.
Check the oil level as shown in the figure below:
upper scale and lower scale. The oil level between
upper scale and lower scale is the appropriate oil
level. Lower than the lower scale means the oil
level is too low, while higher than the upper scale
means the oil level is too full, too little or too full is not
appropriate
6. Wipe the oil ruler before reinserting it completely.
TRANSMISSION AND FRONT GEARCASE
A
B
C
D